Babyono baby camera stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Just a baby camera stand.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 35
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial
Hey, so I just whipped up a quick model for the Babyono baby camera. Basically needed to put it out of the reach of the little one and did not want to mount it on a wall. Utilises the bracket that comes with the camera. The bracket attaches by 3 screws, around 3.8mm thread or so, 16mm length and a 7.8mm head (rough measurements of the ones I used) and you can use the same screws on the base, that needs 4. Probably overkill, but happy to report that the baby has not broken it off yet.
Made this with 3 perimeters just in case and using just regular old PETG at 0.2 layer height, structural setting. The cable routing ended up working well, but to be perfect it would probably be best if it was fully enclosed in the stand leg. I guess an opportunity for an improvement. Cheers!
Thanks!