1 / 7
Sys3 M foam cutting guide
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Guide for cutting foam insert that fit into Sys3 M Systainer
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 87
- Makes
- 1
- Views
- 361
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Guide for cutting foam insert that fit into Sys3 M
Split the guide in your slicer, print and place on shadow foam or the like, cut and enjoy organizing into perfectly fitting foam.
In order to make it bottom out in the systainer, the sides and front have to be trimmed at the bottom.
Steps:
See pictures :)
Flip the cut foam over, lay the guide on top and cut on the inside of the guide as shown approx 15mm deep and 15mm into the side, on the sides and front. Then it should bottom out, otherwise cut a bit deeper.