1 / 4
Modular RJ45 Jack Switch Helper
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Helps in making the migration of Switches simpler
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 68
- Makes
- 0
- Views
- 369
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I recommend the following for the Slicer:
- Manually draw the Seam Line on the edges that are not part of the slide in and set the seam position to nearest
- Elephant Foot compensation to 0.2mm
- Wall Generator Arachne
- To save filament and time you can set Sparse infill pattern to Adaptive Cubic and Sparse infill density to 10%
The “correct” orientation is this one:
Most printers should be able to handle the overhangs on this model without any problems. Admittedly, the models I printed were printed on a Bambu X1C with Bambu Basic PLA, so your experience may vary.
If you have any suggestions on how to improve it, I would love to hear about it.