Epic Pwnagotchi Case for PiZero + WaveShare V4 eink screen

Tested with a Pi Zero 2WH And Waveshare 2.13 inch V4 eink screen (supports Pi Zero WH, Waveshare v3 as well)

Check out my Pwnagotchi guide and plugins too

How to Use: 

First, remove the microSD card from the Pi Zero, then attach the pi Zero to the eInk screen. Now, put the device inside the case such that the holes line up with the ports. Next, you can place the microSD card via the open hole in the side of the case. Lastly, place the lid inside the bottom to seal the case.

Print Recommendations: 

Case - suggested to use supports and 20 to 25% infill 

Lid - no supports required, also use 20-25% infill

For optimal durability, it's recommended to print your case and lid in ABS or PETG rather than PLA. Since the Pi Zero can generate significant heat during operation, PLA components may warp over time due to thermal stress. ABS and PETG offer better heat resistance, ensuring long-term stability and performance.

Notes:

Great for running Pwnagotchi or Bjorn software.

If you would like to use the original lid, this case is still compatible with it.

Supports Waveshare v3 as well but other Waveshare Screens may not work as the ribbon cable placement has changed, check the back of your eink PCB and you will see a sticker with the version number. 

This case doesn't fit an internal battery module (intentionally), there are plenty of other cases that have room for batteries inside. 

Supports optional (can help and avoid bridging issues) 

Infill used - 20% 

If you are interested in using this model for commercial use, please contact me!