Mercury 1.1 BTT HDMI5 Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Combined and modified these two models so I could use the BTT HDMI5 with my Mercury 1.1.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 67
- Makes
- 1
- Views
- 361
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
With this model you can use three heat inserts on the stand piece to connect it with the modified center skirt for the Mercury 1.1. The stand and skirt center connect to the 2020 extrusions using the normal roll in or hammer head type nut and then you can screw your screen on with the bezel. Thread your HDMI and USB-C cable through the hole in the skirt. Because you have to flip the printer to get it all on, hopefully you only have to do it once. I tried to include photos of how I did it all. The blueish filament is Burnt Titanium ASA and is what I am running with on my setup. The red was a test mock up with some PETG. I think I went way over kill as I did 40% infill on the ASA but the 10% infill on the PETG is likely more than stiff enough if you have 4 walls and at least 4 top and bottom layers. YMMV.
Also, if you don't mind, post a make and provide some feedback. I would love to see if anything I am doing is helping someone else. Thanks! Happy printing.