1 / 1
Small baoding ball stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Small 25mm x 25mm x 5mm ball stand to keep decorative balls from rolling around.
Initially this stand was created for ~50mm diameter decorative stone balls.
Printed with PLA and 0.15 Structural Core One default settings.
- Layer height: 0.15mm
- 2 perimeters
- 15% infill
- Material PLA, should also print in other materials without problem.
Uses about 1.7g of material and prints in about 7 minutes (I made 2 at once and used 3.6g of PLA with 14 minutes print time).
Could also try to turn ironing on for smoother transitions (if it helps at all). I tried but with PLA and heat creep had problems with material feed, probably should increase ironing speed to make it faster and avoid heat creep