sharkbyte orqa fpvone goggles shark byte mount Easy print
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed an easily printable and clean looking mount for putting sharkbyte RX on your orqa goggles. flip it over so…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 56
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I designed an easily printable and clean looking mount for putting sharkbyte RX on your orqa goggles.
flip it over so the flat part is on the print bed and it will print with no supports, even the holes are designed for no overhang.
you can use the m3 screw and nut that came with they RX
to put this on the goggles i use 3m tape 1mm thick. it holds good and when needed it cleans up leaving no permanent marks on the goggles.
Print Settings
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
50
Notes:
will work with every filament but i don't recommend TPU as it doesn't seem to like adhesives.
Category: R/C Vehicles