Neopixel Christmas tree
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3d printed Christmas tree with ws2812 LED strip inside Arduino NANO is used as a controller
- Rating
- 5 / 5
- Likes
- 49
- Downloads
- 223
- Makes
- 6
- Views
- 1,760
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
3d printed Christmas tree with ws2812 LED strip inside
Arduino NANO is used as a controller
Print instructions
For the tree use any transparent filament.
You can also experiment with white opaque filament.
For the base use any filament you like.
0.2-0.25 mm layer height, 100% infill for the tree and 25-30% infill for the base, no supports.
Apply a few drops of super glue in order to fix back lid of the tree.
If needed, use hot glue to fix the tree on the base.
Use 470-1000 mF capacitor on VIN and GND pins of the Arduino, as well as 500 Ohm to 1 kOhm resistor on a digital pin.
I used DemoReel100 sketch from the FastLed Arduino library, but you can experiment with any sketches you like.
Happy printing and happy holidays!