QAV-X runcam micro mount

there are 2 mounts in here one is if you want to mount the camera high and partially unprotected and you will need M2x6mm screws for the camera, this provides a snug fit with plenty of build room behind it. also a little protection. minimum camera angle 30max 45 and you will start to see the top of the arch. the other is a new design that i am currently in love with.

I added a new design for a much sturdier mount at 35 degrees, this is protected from almost all impacts by being low and tucked back. this is especially handy as you can remove it without removing the top plate. to install first insert the camera and use the screws that came with your runcam micro any longer and it would fit. second insert the standoffs into the 3d print i made them snug so it might take a little tapping. third plug in the camera and slide the mount into the front of the qav until the stand offs line up then simply install the 4 screws.

there is a hole for a buzzer with a wide slot to accommodate the larger and louder 12mm 5v buzzer.

Print Settings

Printer Brand:

Printrbot

Printer:

Rafts:

Supports:

Resolution:

Infill:

Notes:

Category: R/C Vehicles