Chance's XShot MPP Shroud
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
There are many (kinda) like it, but this one is mine.
- Rating
- 5 / 5
- Likes
- 69
- Downloads
- 284
- Makes
- 4
- Views
- 1,910
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Introduction
A replacement frontend for the XShot Motorized Piston Pump blaster. This shroud replaces the stock front orange piece (and its collet). It uses the tension-band barrel retention system I've been using on some of my personal SCARs as well as the new QuickString SCAR (also featured in the photo). Be sure to take the white plastic “chamber” piece out of the original muzzle and put it into the rear of this shroud before installing. The model features built-in supports and does not need any slicer supports to print well. The supports have been marked in one of the images attached to this listing. A very small flathead screwdriver is the easiest way to pop out the ones up by the blaster end. The two down by the muzzle can be busted off by hand.
Credits
Special shoutout to Zoey of FoxxenCreations (https://foxxencreations.com/) for the model of the original muzzle piece to work off of!
Where can I get it?
This one's unique in that it requires no hardware, so you can print the whole thing yourself. But if you don't have a printer, or just want some excellent print quality, you can also get it from:
Out of Darts: https://outofdarts.com/products/chance-piston-pump-barrel-shroud