GoPro Float using Noodle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The grooves push into the center of a pool noodle so no glue is required.
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 56
- Makes
- 1
- Views
- 595
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
The grooves push into the center of a pool noodle so no glue is required. I print this straight up and down with a brim of 20 lines and 3 layers. This probably isn't needed but for me keeps the rod from falling over accidentally. The whole for the connecting screw is thread tight so you could probably get away without a nut, or use an M5 nut for the end.
Print instructions
Category: Camera Print Settings
Printer Brand: Prusa
Printer: Prusa Mk2
Rafts: No
Supports: Doesn't Matter
Resolution: 300
Infill: 10%, 30% for the connector section
Notes:
It is likely you will need to flip the model over in your slicer. There is a flat section.