1 / 2
Veloster FS 1st Gen Rear Hatch Button Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bracket to stop the rear hatch button from falling out of the casing stopping you from opening the hatch.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 60
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
Make sure to print in ABS or ASA, as this goes in a car that may get very hot.
Flip the print over or you will be using a lot of supports that are unnecessary.
Print settings I used (Voron 0): Arachne, 0.2mm heights, 6 solid layers, 40% infill
This is installed above the button with the two screws through the casing.