Swaggy Taser with case

My most recent probably final version.
Case automatically locks switch from turning on the taser.( just make sure you orient the switch the right way obviously)
The case needs to be upscaled by up to 5% , depending on how tight of a fit you want, and your printers tolerances.
Make sure to internally isolate things , like thin wires that dont have a thick enough insulation , because theyll arc.
You can use hot glue, l recommend liquid electrical tape.
Taser is superglued together
Need electrical knowledge to wire this up

Parts from aliexpress:
16mm button - https://a.aliexpress.com/_EHxsjRc
led + resistor
lithium charging board
18650
basic cylindrical arc generator
switch - https://a.aliexpress.com/_EzIFuPu
4 studs "7x9mm"   + 3mm bolts (instead of the ones that come with the studs) (( I used some different studs in the taser in the pic but these will work and better)
2 studs "10x4.7mm" ( I think I used the bolts that came with it but barely, you can also use 3mm bolts with a washer)
https://a.aliexpress.com/_Ey30uLC