Nerf Big Bad Bow MegaXL Dart Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A dart holder for the Big Bad Bow that allows you to use Mega XL darts instead of 9-inch arrows.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 3
- Makes
- 0
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution
Did you know the Big Bad Bow is almost perfectly compatible with MegaXL darts? Ditch those 9-inch arrows and increase your capacity at the same time! I designed this mod to be reversible, but I'm not sure why you would want to remove it.
Files are pre-oriented and the mounts need supports. I recommend straight/normal instead of tree supports. I printed with two walls and 15% infill and they seem to work just fine.
Instructions
1. Take apart your blaster and remove the air restrictor. It just falls out.
2. Remove the existing dart holders. I drilled out the centers, then used pliers to remove excess material.
3. Insert the new mounts. There's one for each side.
4. Add a retaining cap. You can secure it with an M3x8mm screw or even glue, but it seems to friction-fit decently enough too.
5. Press the tubes on either end until they can't go any further. They should friction-fit, but a dab of glue is recommended as I had a tube fall off during testing.
6. Reassemble your blaster.
7. Add darts to the holders, then remove them for a satisfying pop.