Mounjaro supply box

Sharing as someone asked for the STL files. This is my very first project, so be kind. :)

I created it in Tinkercad because I have yet to figure out how to use Fusion 360.

I wanted something to store my Mounjaro supplies neatly, so I created this custom box to fit my supplies.

It's not perfect, but it works for my needs. You are welcome to make edits/improvements as you see fit.

I printed the text and box separately because I used white PLA and orange PETG (that's what I had on hand). I created an embedded void for the text in the lid, then snapped and glued the letters in place. I had to use a ton of brims for the text (especially the smaller text,) and it was a bit of a pain to remove the brim for the tiny font. I made it work in the end, but if you have the colours you want in the same filament, I strongly suggest you print it all in one go. 

Printing them separately is doable, but a lot of extra work.

The lid sinks into the box slightly but I also used one small magnet in the centre of the box and lid (5mmx2.65mm) just to keep it a bit more secure. Mine lives in a drawer, so I just needed something that would avoid the lid rattling about.

I'm not very practised in designing models, so any comments/suggestions on what I could have done better are always welcome.