Glas-Aluminum Greenhouse Door Slider
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Greenhouse door slider for 30 year old aluminum frame glass greenhouse.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 4
- Makes
- 0
- Views
- 97
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a slider for a 30 year old greenhouse door. It fits an L shaped plastic profile, 20mm x 30mm (2.5mm wide) ,that is screwed to the floor with the 20mm side sticking up.
It is best printed in ASA (because it's outdoors), but PLA also works, but probably does not last very long.
It has a space for an M6 nut, and it has a hole for an M6 screw.
It takes 4 pieces (2 for each door, replacing the existing system).
The 45° angle on the rail interface are inspired by steam locomotive cow catcher - the idea is to flick away any stones or debris that gets into the system.
The tolerances are about 0.2-0.3mm, and it slides smoothly on the plastic rail.
I used a countersunk M6 screw from the bottom because of the low profile to avoid scraping on the plastic rail (which also had countersunk screws).