PCI slot cover with (female) cable holder for offset GPU
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Single slot PCI cover with configurable cutouts to hold (female) HMDI / Display Port cable.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 13
- Makes
- 0
- Views
- 197
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This facilitates GPUs that are mounted in such a manner that their PCI slot does not line up with any available PCI slot on the case and require a more MacGuyver style approach.
Since I had to run my cables through an open PCI slot and navigate an X+Y offset GPU riser, it is quite a struggle to manage those cable or even simply unplug them to move the case for maintenance. This print allows for 2 extension cables to be mounted and exposed as a regular ports on a PCI slot.
Dimensions of the cables are highly personalized, I may want to revisit to find a more physical configurable approach or perhaps even a more universal design. In any case - no pun intended - this was designed in OpenSCAD with configuration for most of the relevant dimensions made controllable. I probably over did that part. This was my first non-basic OpenSCAD project, so I'm sure there's a lot of room for improvement. You can also configure things to the point where the whole model and assembly will break, or even place screw holes in places that do not make sense and may damage cables or more if not reviewed properly. So use common sense.
As for the print itself, there are 3 parts to print and assemble.
- cable holder base
- cable holder lid
- PCI slot cover
The goal was to have a single cable holder bottom + slot cover part, but the complexity of that part would mean the slot cover being printed vertically which requires too much support to yield a clean looking piece. Parts can be selected so you could export an STL of either bottom or lid with the slot cover and have a crack at it. I committed manually implemented supports, frankly because I didn't want to. I might do so later but there's bigger fish to fry in my 3D printing journey at the moment.
In any case, configurable screw holes are available. You can also just disable them. Just be safe when securing the parts.
Use non-conductive and heat resistant materials, e.g.: ASA, to print and be careful if you opt to go with magnets to attach the parts as I'm sure that if they get lost in your PC case it has the potential for significant damage, or perhaps even interfere with the signal passing through the cables.
If you want to tinker with the OpenSCAD code, you'll need the [BOSL2 library](https://github.com/BelfrySCAD/BOSL2).
Bill of materials
(using default configuration)
- 12x M3x18 countersunk
- 2x cable (as needed)
For the cautious and paranoid; thread locker to prevent case vibration from loosing screws and them wreaking havoc.
Print settings
ASA seems a given as parts should be printed in a non-conductive material that can deal with heat in a PC case, possibly some heat on the cable connectors themselves.
Wall and infill based on paranoid tendencies, you could probably reduce but make sure to test and validate.
- Auto orient should place parts just fine.
- Some support for the slot cover will be needed due to the overhang of the lip that seats the slot cover in the PC case, if you print it vertically you'll definitely need support but I'd advise to lay the slot cover flat on the bed to to print to reduce the potential for visible artifacts. Snug support should work nicely.
- Filament: ASA
- Walls: 5
- Infill: 30%