QRP Guys EFHW Tuner Case

This is a snap shut case for the QRP Guys EFHW Tuner.  The print of the top cover requires supports around the wire wingnut posts.  The rest of it should do ok without supports.  In fact, it is best to block supports for the divots where the tabs snap into the top of the shell.  I gave pretty good variance to the holes that should account for tuner assembly variance, but as always check before you print.  This is not going to be water tight, but could be made so with some silicone or liquid wire tape if you really wanted to go that far.  The recessed letters for the tune switch are a little hard to read, but that was the best system font I found at the time.  Feedback is welcome.