Glo Hyper Pro Charging Dock / Stand

Necessary tools/materials:

• Original USB cable attached to the Glo Hyper Pro
• Allen key 
• 2pcs M4x8-16 allen key bolts 
• Soldering iron , heat insert tool
• 2pcs M4 heat inserts (max 8mm long)
• optional: 2pcs magnets (6x18x20mm max)

Printing:

• Scale:
  PLA/PETG - 100%
  ABS/ASA -  100,5-102% (depends on material shrinkage)
• Walls: 4
• Infill: 10-20%
• No supports

Assembly:

• Set the 2 heat inserts in the Glo Top piece flat or deeper. (if you set it deeper you might have to use longer bolts)
• Remove any remaining burr. 
• 
• Optional: drop 2 magnets in the slots of the Glo Bottom (or use glue/doublesided tape etc…)
• 
• Thread the USB cabel trough the Bottom piece T shape then push it in the Top piece and slide them together until parallel.
• Screw in the bolts. 

I was printing the :

Orange :

• eSUN eSilk-PLA Jacinth
• Generic PLA Rapid settings
• infill: 15% Honeycomb
• scale: 100%

Black:

• Prusament ASA Prusa Galaxy Black
• Prusa ASA settings 
• infill: 15% gyroid 
• scale: 100,5%
• Fuzzy skin : Contour, Voronoi: Points:0,3mm Thickness:0,2mm Feature:1mm
   

Magnets glued to the bottom so they don't rattle.