Dog leash length adjuster
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.07 – €3.75 net (excluding VAT)
For file: dog_leash_shortener_0.4n_0.2mm_PLA_MK4S_2h41m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.41 excluding VAT (range midpoint).
- Weight reported by the author
- 58 g
- Print time reported by the author
- 2.68 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Wraps and secures dog leash to adjust length.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 0
- Views
- 158
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution
Lets you adjust your leash length. I use this with an auto-braking adjustable leash. (My local park has an 8ft leash limit, and i just couldn't find an 8 ft adjustable leash). I've only tried this with a 30 pound dog, but it's worked great for the past year.
Test prints were printed in pink to match Barbaras harness, but when the dog was unclipped and the leash was still clipped to my belt, the shortener had a vulgar ‘pendulous’ look to it when I walked. Recommend printing in “not fleshy” colors.
Designed to print without supports, and with strong layer line orientation.
- Insert the leash through the tube.
- wrap the leash around the “H” shaped piece until you reach the desired length.
- Slide the tube over the wrapped leash.
- Slide the caps over the leash at each end of the tube.
- Align the tube grooves to the cap grooves.
- Push down, then twist to lock in place.
Room for improvements:
The center tube could be flattened to add changeable message/warning plates for reactive dogs or dogs in training.
I've included the fusion 360 file for this if you want to change the parameters. I didn't build this intending to release it, so the source file is a bit of a mess.