Aqara door sensor case (MCCGQ11LM)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed this case in Fusion 360 for an Aqara door sensor mainly to use it for projects where I use this sensor as a…
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 202
- Makes
- 0
- Views
- 2,164
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I designed this case in Fusion 360 for an Aqara door sensor mainly to use it for projects where I use this sensor as a general purpose zigbee sensor and I prefer something a bit smaller.
There are 2 versions, one with a hole and one without it, and also included the Fusion 360 file.
The one with the whole was designed to fit a small wire connector, which makes it handy to plug something else in there, or just use it as a normal door sensor if needed.
You might want to reduce the size slightly when printing, as I made it a bit bigger than the board itself, as the initial plan was to have the wire from the bottom to the top through the side of the board and solder it where the reed switch is, so I needed a bit of room. I ended up soldering the wires to the D+ and - directly to the board.
Use supports for the hole version.
Print Settings
Printer:
Artillery Genius
Resolution:
0.2
Infill:
20%
Category: Electronics