1 / 3
VW Touran/Golf/Passat/Tiguan Trunk Lid Lock Guide Cargo Cover Roller Blind Repair Slider. Opravný jezdec / koncovka pro roletu kufru — image 1
1 / 3

VW Touran/Golf/Passat/Tiguan Trunk Lid Lock Guide Cargo Cover Roller Blind Repair Slider. Opravný jezdec / koncovka pro roletu kufru

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

VW Touran/Golf/Passat/Tiguan Trunk Cargo Cover Roller Blind Repair Slider. CZ Opravný jezdec / koncovka pro roletu kufru

Rating
0 / 5
Likes
7
Downloads
72
Makes
1
Views
564
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution

This is a replacement end cap/slider pin for the retractable trunk/cargo cover (parcel shelf) of a Volkswagen Touran (2017, 5T model). The original parts tend to become brittle and break over time. Replacement of the whole Rolette is like 200 Euro. 

I designed this for my VW Touran 2017. However, due to the shared platform (MQB), it is highly likely to fit other models of the same generation, such as:

VW Golf (Mk7)

VW Passat (B8)

VW Tiguan (Mk2)

Skoda Octavia, Superb, Kodiaq

Seat Leon, Ateca

Please, if you print it for another model, leave a comment to confirm if it fits!

Printing Recommendations: I recommend printing this in PETG or ASA/ABS But PLA should be fine too

Layer height: 0.2mm - 0.3mm

Infill: 30-50% or more for durability

Supports: required

CZ

Jedná se o náhradní koncovku / jezdce pro stahovací roletu krytu zavazadlového prostoru (plato) pro Volkswagen Touran (rok 2017, model 5T). Původní díly mají tendenci časem zkřehnout a praskat. Výměna celé rolety stojí přibližně 200 eur.

Tento díl jsem navrhl pro svůj VW Touran 2017. Díky sdílené platformě (MQB) je však velmi pravděpodobné, že bude pasovat i na další modely stejné generace, jako jsou:

VW Golf (Mk7)

VW Passat (B8)

VW Tiguan (Mk2)

Škoda Octavia, Superb, Kodiaq

Seat Leon, Ateca

Pokud díl vytisknete pro jiný model, zanechte prosím komentář, zda pasuje!

Doporučení pro tisk: Doporučuji tisknout z materiálu PETG nebo ASA/ABS, ale i PLA by mělo být v pořádku.

Layer height: 0.2mm - 0.3mm

Infill: 30-50% or more for durability

Supports: required

Tags