Gopro mount countersunk for M4 locking nuts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
GoPro mount for countersunk M4 locking nuts.The nut that will sit underneath the GoPro nut could be moved 1mm farther…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 12
- Makes
- 0
- Views
- 47
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Public Domain
GoPro mount for countersunk M4 locking nuts. The nut that will sit underneath the GoPro nut could be moved 1mm farther out to the side in order to be easier to insert, but I had to match pre-drilled holes in my helmet with this one. The slot in the bottom will accomodate the bottom of a snag-prevention shield, for use in skydiving (https://www.thingiverse.com/thing:2432876).
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
Yes
Supports:
Yes
Notes:
Print this thing lying on it's side, with supports and a raft, for quite a lot of additional strength.
I recommend printing in this direction for skydiving or high speed or vibration sports. Printing it upright will make it look better, but it will delaminate much easier. I was unable to break a lying-down PETG print by hand, but I could relatively easily break the standing-up print.
Check that the raft lines are perpendicular to the direction of the tabs, in order to get the best quality. if you use Wanhao-Cura, you can rotate the model 90 degrees if they go the wrong way.
Category: Sport & Outdoors