1 / 4
Autolevel plate for CTC PI3 Pro B
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Plate for mounting an autolevel inductive sensor on a CTC PI3 Pro B. The sensor is an inductive probe SN04-N. You will…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 165
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Plate for mounting an autolevel inductive sensor on a CTC PI3 Pro B.
The sensor is an inductive probe SN04-N.
You will need to mod the GT2560 motherboard to connect it to the sensor. Put a male pin on the 5v pad, and solder right angle male pin to the mosfet GND (see photo). The sensor line goes to the bottom pin on z-max. You will need Repetier firmware instead of Marlin.
You will need two 50mm M3 screws to reach to the other side of the extruder plate.
Category: 3D Printer Parts