1 / 3
Multiscan35 | Print-in-place 35mm XPan Slider and more scan holder — image 1
1 / 3

Multiscan35 | Print-in-place 35mm XPan Slider and more scan holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Scan holder for multiple types of film

Rating
0 / 5
Likes
3
Downloads
27
Makes
1
Views
155
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

This was designed with print-in-place in mind to be used with a light table setup.

No assembly required, just print as shown on the 3mf file (only needs supports on the center).

First print the lower half of the design (you can use the modifiers in orca slicer to achieve that) to test your tolerances as the channel for the film is very thin which is necessary to keep the film as flat as possible. 

Right after printing, clean as much of the supports and printing artifacts and insert a scrap piece of film to remove any artifacts inside the film channel.

If you run into issues, you could try scaling things up a bit on the problematic axes (the z and the one that is perpendicular to the slot).

---

## Supported Formats (with masks)

- XPan with sprockets (65 × 30.6 mm)  
- XPan sprockets covered (65 × 24 mm)  
- 2" × 2" slides (52.5 × 52.5 mm)  
- 126 film (28 × 28 mm)  
- 35 mm with sprockets (36 × 28 mm)  
- 35 mm sprockets covered (36 × 24 mm)  
- Half-frame with sprockets (17 × 28 mm)  
- Half-frame sprockets covered (17 × 24 mm)  

Film is held only outside the sprocket holes to keep scans flat and scratch-free.