Makita 18v to Makita PA 14 (Nicad) Adaptor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Makita 18v to Makita PA 14 (Nicad) Adaptor *** You will be over volting you tool ***
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 49
- Makes
- 0
- Views
- 234
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
*** You will be over volting you tool ***
Makita 18v Battery to Makita PA 14 (NiCad) Tools Adaptor
Extra requirements
2 x 9.5mm male spade terminals
2 x 6mm piggyback terminals
7x M3 nuts
7 x M3 10mm socket head bolts
2 x wires
2 small zip ties
*** You will be over volting you tool ***



Assembly Guide
I find if I run a 3mm drill bit through all the bolt holes, it helps with getting the bolts in smoothly.
Install wires onto male terminals, clip off the small wings on each side and flatten out the delta shape between the crimp and the spade, this will help it fit into the slots of the adaptor. Install the male terminals into the bottom section and feed the wires through the hole, install the cover plate with a nut and bolt.
Place the top roughly into position so you can estimate where to trim the wires. Once trimmed, install the piggyback terminals, I give them a squeeze so they will fit nicely in the final position.
Use 4 x nut and bolts to combine the top and bottom, obviously feeding the wires and piggback terminals into the post section.
Put the side buttons into position and use the remaining 2 nut and bolts to secure them.
Install the piggback terminals into position, noting the correct polarity, use the small zip ties to hold them snug, be sure the put the zip tie lock on the inside of the post. It's a bit fiddly but I use a small needle nose plier to help.
Install the top cap over the piggyback terminals, you can glue in place if you wish.
*** You will be over volting you tool ***
I can adapt to other slide in style batteries, just let me know and I can probably make it.
If you like this model, please throw me a like. Designing the models is time, filament and coffee consuming. If you want to support my work buy me a coffee (PayPal). Thanks!