Sunlu S2 Filament Dryer Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Redesigned a magnetic bracket for the Sunlu S2 to screw directly into the wooden side-rail of a printer cart.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 31
- Makes
- 0
- Views
- 222
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The original bracket by @Ibot_3D was a great fit with the Sunlu S2 filament dryer, but I couldn't rely on the magnets to hold the bracket on the cart. It was too easy to knock the dryers onto the floor by brushing against them (or perhaps leaning on them like an idiot).
I imported the original Inventor (.ipt) file into Fusion as a solid body and redesigned the part to screw directly into the wooden side-rails of our printer cart. Design changes:
- Added through-holes so you can drive mounting screws from the outside of the part. Requires a driver bit that is 160mm (6.3") to reach all the way through. Assumes a driver diameter of 12mm.
- Expanded the mounting screw holes to accept a 16mm (1/4") washer, to spread the load of the cheap 50mm-long (2"-long) IKEA woodscrews on the printed PETG part.
- Expanded the slot for the cord so that the dryer would be easier to plug and unplug while the bracket remains screwed to the cart.
I've included the modified parametric Fusion file so that you can adjust the hole diameters for your preferred screws, washers and driver bits.