Clips for (halfround) LED-strips
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.44 – €1.76 net (excluding VAT)
For file: 16 Clips LED-Strip_0.15mm_PLA_MINI_1h53m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.60 excluding VAT (range midpoint).
- Weight reported by the author
- 14 g
- Print time reported by the author
- 1.89 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Simple clips to be attached with double-sided-tape
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 92
- Makes
- 5
- Views
- 467
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I found an old LED-Strip which I wanted to use for the box my PrusaMini sits in. The clips are very simple, print laying down (I tried it standing up, but it just takes much longer and the others are by far string enough), and can be attached with double-sided-tape. I also did a version with a wider base for more glueing surface, as especially in the bends the glue of the small clips was not strong enough.
Note that the clips are intended for the “halfround”-LED-strips, maybe you can scale them if yours is of a different size. it is easy to clip them onto the strip but relatively hard to remove it again, you can however slide them around on the LED-strip if neccessary.
Printing worked well at 0.15mm height or even variable layer height.