RepRack Retension Clip REMIX
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Push-in retention clip to ensure that the hangers do not “jump” out of the cleats/adapters
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 28
- Makes
- 0
- Views
- 116
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Looking back, I probably should’ve figured out how useful those Retention Clips are before installing my RepRack. Would’ve saved me a good amount of sweat (and a few questionable words) while wrestling the rods and their locking screws into place.
So here’s my tip: if you’re building a RepRack and printing the parts anyway, don’t skip the clips. They only cost about 1.5 grams of filament each, and they’ll make your life a whole lot easier—and safer, too.
Printing information
All STL files are correctly aligned.
Layer height: 0.2 mm
Perimeter: 2
Infill: 15 %
Support: no
I am looking forward to your Makes! :-)
If you like this design, feel free to check out my others here.