Vinyl Record wall holder (extruding)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple Holder for a Vinyl + Cover with the Vinyl extruding from the cover
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 107
- Makes
- 1
- Views
- 749
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The vinyl extrudes from its cover about half of its diameter. The display can be mounted with two snug screws (dont overtighten them, they don't need to withstand that much weight) or adhesive tape if you have one strong enough.
I added a third, seperate part (Topholder) that is put to the wall with adhesive tape to keep, especially thicker Covers, from tipping over.
The display is printed in two seperate parts (the case-holder and the vinyl-holder wich then are put together. Use a little glue to make sure the parts dont seperate.
Pole V2 added feature:
I added a sligtly higher tip at the end of the pole to make sure a vinyl cant slide off, the printing stayed the same.
When slicing, make sure the pins on the holder point to the top and the half hole of the vinyl-part is pointing downwards so that they fit together. The Topholder is best printed on its side for most stability, it will need a brim. (No supports should be needed)
The record shown in the photos is Abbey Road by The Beatles. It’s only there to show how the holder works and is of course not a part of the model :)