1 / 3
Parts Storage for Wall Slot Shelving - simple hook for grinding discs and sanding belts etc. — image 1
1 / 3

Parts Storage for Wall Slot Shelving - simple hook for grinding discs and sanding belts etc.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Storage hook for lightweight items on wall slot-riser type shelving.

Rating
0 / 5
Likes
3
Downloads
3
Makes
0
Views
85
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Bonded grinding and cutting discs can absorb moisture in a damp garage or workshop, this damages the bonding and the discs can fail prematurely. It's bad enough that they have to have an expiry date (usually stamped on the hub or sometimes printed on the disc), but bad storage can reduce that still further.

The same applies to sanding belts - the glue bonding the joint breaks down if they get damp so they need to be stored in a relatively dry atmosphere and not folded up or scrunched or squashed. 

I have a load of slot-mount shelves indoors but they're already pretty full, so I wanted something that would hang off the back edge of a shelf without having to be attached to it (or the wall) in any way so it could be moved around as desired. Discs and belts are very lightweight so no great need for strength here, just something to hook them onto.  

The vertical slot frames are about 16mm deep, so anything that's just a bit less than that will be retained securely with no risk of falling off. If your shelf has a free end like mine in the pic, then you can just slide it in from the end. If you want to hang it from a section that's bounded at both ends by wall or vertical frame, then just pull the shelf out a little way to get the hook in and slide the shelf back home.  This doesn't work if you've slotted out your shelves to clear the frames so the shelves are flush with the wall, sorry :o)

Print in any hard material from PLA upwards. I used PLA+. No special settings, although I tweaked the infill up to 20%, otherwise all standard print settings, no support or adhesion needed. I used 0.4mm nozzle, and 0.28mm layers just to get it done quickly.

Print it flat, not standing up. When flat, the layers are along the long sections so the perimeters will contribute to the strength. If printed standing up, one or other of the long sections would have layers crossing it, and could separate under heavy loading, although this hook shouldn't need to be loaded heavily for this application anyway. I could have made the rear section thicker, but again in this application that would just be a waste of filament.

Now my discs and belts take up no space at all. Well, not on the shelves anyway!

Please Like this model if you find it useful.

If you REALLY like it, https://www.buymeacoffee.com/gigabeast :o)