CRUX35 DJI 04 lite bracket

Fixed 20 Deg version. I will publish more fixed angle versions later.

Print 2off flat using TPU no supports required.

With rocksteady off some intermittent very slight vibration is present in the camera recording and feed. With rocksteady on the camera recording is quite bad although the feed is acceptable. Hence keep rocksteady off.

Inspired by the great work of Hunter Ligeti. I've printed and used his brackets although I had some issues with them:-

The camera mounting holes were 3mm for the M2 camera bolts I've reduced these hole to 2.5mm.

The bracket are a little week hence I've made them stronger (less cutouts) although mine will be very slightly heavier.

My props touched the variable angle version, hence I melted the brackets with a soldering iron.

When using the variable angle version with limit up tilt the mounting bracket is visible in the camera feed, hence my proposed new design's.

The brackets were a little loose in the frame (I applied some silicone to secure tham) mine are a tighter fit and don't require any glue.

My intention is to produce fixed angel designs from 15deg through to 55deg in 5deg increments. With the camera placed further back for all variants above 35deg so that the props don't hit the brackets.