Begleri Bead V2 - for 550 Paracord
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple bead for a begleri toy, hole recessed for knot in paracord
- Rating
- 0 / 5
- Likes
- 31
- Downloads
- 115
- Makes
- 0
- Views
- 559
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial
This is a model for a begleri bead that does not require hex nuts, a slightly smaller and more refined version. When printed at high density (90% +) it gives good weight for the toy.
Paracord requires a simple overhand knot and then it can be pulled into the cavity so you do not see it.
I recommend printing out of PLA or PETG, ABS and ASA are much lower density and wont give as much weight.
TPU would also work and is a similar density to PLA, this would make them less loud when they bang together
This took me 1 hour to print 2 beads on my Bambu labs p1s at 97% density and a 0.2mm layer height so it is a relatively quick print
PRINT SETTINGS:
0.2 or 0.28mm layer height, detail is minimally affected so dealers choice
90% or higher infill for good weight
no supports or brim should be required