Zenith Mk.I 3d-Printable Aircraft
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3d-printable rc aircraft, with an 80cm wingspan and a 40cm long fuselage.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 16
- Makes
- 1
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
A 3d printable aircraft with an 80cm wingspan and a 40cm long fuselage. The wings use NACA 2412 aerofoils. The horizontal and vertical stabilizers use NACA 0012. The electronics are interchangable; any electronics work. The original Toad Aeronautics version utilized 9-gram servos, a 40 amp esc, an 1800 kv motor, and a 3s 2200 mah lipo, though as long as the electronics fit into the desired place, it should work.
NOTE: You will have to cut out the control surfaces yourself. You must also create hinges for the aforementioned control surfaces, and you will need to cut/carve pockets for the servos.