Simple filament storage containers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple storage container for filament without the need for external hardware
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 29
- Makes
- 0
- Views
- 188
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About
I was looking for a simple storage box to store filament without the need for hardware to assemble it. No screws etc. No unwanted holes to cover. I ended up designing this to store my filament, but assembly does require glue.
Why expandable?
To save some material I decided to design it with a shared wall between the compartments. This works quite nicely, especially in the ‘full’ versions. There are 6 variations included:
- single full box
- single expansion box
- double full box
- double expansion box
- tripple full box
- tripple expansion box
The expansion boxes can be glued to the single boxes. The tripple full just fits on the build plate of the Core One. I prefer the tripple boxes, making them bigger also makes them havier with the rolls inside.
A tripple full box, 3 lids, 3 clips, 3 sample holders and 3 samples is 914g of material (305g per spool) + 12g TPU (4g per spool).
Printing
I printed the boxes in 0,25mm layer height - print them with the front side of the box facing up. I also tried 0,32 and 0,4 layer height but that caused the clip to no longer fit. I suggest 0,2mm for the other parts.
Warping is the biggest enemy for this print if you want to use the extension versions. If parts warp differently they might no longer fit together. If you are going to do this then print all parts in the same direction and let them cool off before removing.
Assembly
Put a tiny bit of superglu on the sample holder before pushing it in the lid. Let it dry completely before placing the sample or it might be permanently attached… At first use the clip might be hard to get in place.
When gluing an expansion to a full box, put the expansion on a flat surface with the missing side up and the front side facing you. Put glue in the groove and place the full box (or the other expandion) on top and make sure it slides in place. Use a filament spool to add extra weight to push the parts together.
The TPU ring can be a bit of a chore. If your filament is a bit stringy like mine remove all exess before assembly. Once used the pressure of the lid on the box ensures it will remain in place and it will be easier to close the next time.