Tricut brush mount for Roborock s50
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adjusted mounts fitting the Tricut brush in the Roborock s50 brush tray.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 32
- Makes
- 0
- Views
- 882
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Some time ago, one of my friends told me about the Dreame Tricut brush for robot vacuums, which solves the problem of long hair wrapping around the brush and needing to be cut off from time to time. I ordered it without doing much research and soon realized that most modern robot vacuum brushes are a few millimeters longer, meaning it doesn’t fit in my old Roborock S50. Luckily, I have a 3D printer and some basic 3D modeling skills.
Here you can find side mounts for the Dreame Tricut brush 2.0 (I’m not sure if they work with the first version, which has non-replaceable brushes). They are remodeled from the originals but adjusted to fit the Roborock S50 and similar brush trays. Some original parts of the brush and the brush tray cover also require slight modifications.
- The rolling side of the Tricut brush is connected to a metal axle, which transfers motion to the cutting blades. Since the axle can’t be pushed further inside, I cut about 1 mm from the brass tube inside the plastic hexagonal piece so it could slide in deeper.
- The screws holding the rolling side mount also need to be shortened by about 1 mm; otherwise, they can strip the thread if screwed too deep. I cut them with pliers and polished the ends with a file.
- The new brush has no grooves for the metal wires on the brush cover, so those wires need to be cut as well. It’s worth filing down the cut ends to remove sharp edges and prevent scratching.
Both mounts require supports, and this is the trickiest part. When printing in a single material, the printer usually starts about 0.1–0.2 mm above the support interface. This not only creates a rough surface but can also add unwanted height to the final print. A possible solution is to use two materials (e.g., PLA for the support interface, when printing with PETG) with zero interface spacing. However, this didn’t work on my single-color FlyingBear Ghost 5 with manual filament changes—the part above the support interface failed to stick even to the same material.
What did work for me was pausing the print after the support interface and coloring it with a permanent marker. This creates a thin separation layer: it doesn’t add a noticeable gap, but the next layer won’t adhere too strongly, making the support easy to remove without damaging the main print.
I also added two detachable rings to reduce stress on the axles and improve overall brush stability.
Everything was printed in PETG and has been working very well for some time.