Ikea Skådis hook for ropes, cords, etc. (T-Nut)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a hook for ropes, (electrical) cords etc. to be used with Ikea Skådis pegboards and M2.5 T-Nuts.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 22
- Makes
- 0
- Views
- 139
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a hook for ropes, (electrical) cords etc. to be used with Ikea Skådis pegboards and M2.5 T-Nuts.
Dimensions: 40mm high, 20mm wide, 8mm thick
It prints without supports lying on the face or on the side.
For assembly you need:
- M2.5 T-nut
- M2.5 DIN934 Hex Nut
- M2.5 Screw (16mm)
- M2.5 Washer
- 40cm of 2mm cord (e.g. this one from Amazon)
To assemble, put figure-of-8 knots (Wikipedia) in the very ends of the 2mm cord. Don't leave too much cord sticking out at the ends, it's a tight fit. Stuff the knots in the holes on the back of the hook and insert the cord into the grooves. Screw the hook to the Skådis board.
If needed, I can make versions for M2 or M3 T-Nuts.