Minisforum BD770i / BD790i / BD795i / BD790i X3D Asetek/Corsair AIO adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This adapter ring allows the mounting of any Asetek 4th Gen AIO, Corsair, NZXT, etc. on the Minisforum ITX MODT boards.
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 132
- Makes
- 0
- Views
- 1,662
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
The Minisforum ITX boards support an unusual hole placing for the cooler mounts, 52mm on the edges. The model by NAnglo uses a slighty wider spacing, therefore I needed to adapt it a little bit.
Print with temperature resistant and robust filament and solid infill to achieve best stability.
To use the adapter on the board you need a compatible Asetek-built AIO, 4xM4 hex nuts that fit in the adapter snuggly, 4 M4x25mm screws with a flat bottom.
The adapter ring is a very tight fit over the pump unit. You need to squeeze it carefully. Maybe a little bit of sanding down the inner diameter can help. Turn the screws in and out several times before mounting to ensure that they go in unobstructed. This helps in achieving an even torque later.
Be careful not to overtighten the screws as you are mounting directly to the CPU die! If you can, use a torquemeter and apply 0,5Nm at max.