Ryobi P503 5-1/2" Circular Saw Edge Guide and Saw Blade Bushing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Saw edge guide and 16mm (5/8") to 10mm saw blade bushing for 5-1/2" Ryobi saw.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 23
- Makes
- 0
- Views
- 301
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Another thrift store find. A $7.50 circular saw with a bad blade. Best deal for a new saw blade was $5.50 at Amazon but had a 5/8" hole. A made a bushing that is actually a little wider than the blade. There is a recess on both plates that sandwich the blade. I wanted to make sure the ring would not work its way off to one side. Print with 3 walls and a raft should give you a good solid ring for a 10mm shaft.
The edge guide slide was a piece of aluminum I bought from Home Depot. It is marked as 1/16" x ½" x 3 foot long. The ½" is more like 13mm and is a little too wide to fit. I trimmed the width with a carbide tip table saw with a zero-clearance throat plate to ½" and it fit just right. The guide was printed with no support for the blade slot. I figured it would be harder to remove the support material (if any) than to just clean the slot out. Two 4mm set screws hold the blade in place. The removeable block allows you to trim very thin slices since it can be moved very close to the saw blade. It is held in by two 4mm x 12mm screws. Threads are formed in the parts when printing. Parts are printed with 0.2 layer, 3 walls, 20 to 25% infill. I used generic black and 3D Fuel Lulzbot Green PLA filament.