1 / 2
Sky-Watcher Flextube 300P dual speed focuser upgrade — image 1
1 / 2

Sky-Watcher Flextube 300P dual speed focuser upgrade

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a dual speed focuser knob upgrade. It's retrofit. The speed ratio is about 4.68:1

Rating
0 / 5
Likes
11
Downloads
70
Makes
0
Views
444
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I was looking for a dual speed focuser retrofit upgrade kit for Sky-Watcher Flextube 300P. The only one I found was the Lacerta one, but it's expensive and not easy to get in the US. I decided to design my own. Luckily I found knighttm's design, and I liked it. I adapted his models to work with Sky-Watcher 300P. I used friction wheels instead of gears to get rid of backlash. 

I have only tested with planet_v3.stl with 3 O-rings on each wheel. When I turn the small knob, I feel a little bit spongy, but not bad at all. If you don't have the O-rings on hand, you can print planet_no_groove_v1.stl instead. You'll need a thin layer of liquid electrical tape or plasti-dip on the contact surfaces to increase friction. 

Please refer to the attached PDF file for assembling instructions.

BOM:

  • 676zz(mr106) x2
  • 6704zz x1
  • M3x12mm Socket Cap Head Screw x4
  • M3x22mm Socket Cap Head Screw x3 (use 20mm for regular nuts)
  • M3 Nyloc nut x3 (or regular nuts)
  • M3 hexagon nut x1
  • M4 hexagon nut x1
  • M3 socket set screw x1 6-8mm
  • M4 socket set screw x1 6-8mm
  • M6x8mm threaded insert x1
  • M5x6mm threaded insert x1
  • O-ring 9mm OD, 6mm ID x 9
  • Dowel pin, M3 12-14mm x3 

Print parameters:

  • material: ABS recommended
  • nozzle: 0.4mm
  • layer height: 0.2mm
  • infill: 40%
  • support: no
  • seam: scarf joint or scattered