tinySA Basic Enclosure — Slim 2-piece, no supports, uses original screws
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
tinySA Basic enclosure: slim two-piece, no supports; uses original screws; lanyard holes; clean heatbed texture.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 78
- Makes
- 0
- Views
- 311
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Description
A tidy, low-profile enclosure for the tinySA Basic. I couldn’t find a non-bulky case, so I designed this one as two halves that print without supports and reuse the tinySA’s original screws to assemble. It keeps the footprint slim while protecting the screen and edges. I also added two small holes for a lanyard/loop.
Compatibility: designed for tinySA Basic (USB-C on the top, jog wheel and button on the top edge). Not for tinySA Ultra/Ultra2.
Highlights
Two-piece shell prints flat, no supports.
Reuses the factory screws—no extra hardware required.
Slim fit: tight, tidy design that avoids the usual bulky look.
Lanyard/loop holes on the top edge (optional use).
Clearances for the SMA connectors, USB-C, jog wheel, and top button.
Oriented to let the heatbed texture become the exterior finish.
Bill of Materials (BOM) / Hardware
Uses the original tinySA Basic screws (front-corner screws).
(Optional) short lanyard/loop cord.
Safety
This is an enclosure only. Ensure ESD care and avoid mechanical stress on the SMA connectors. Use at your own risk.