1 / 1
GOAT multitool scalpel blade sleeve replacement
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A holder for the scalpel blade on a GOAT multitool
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 82
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I realised the sleeve that holds the scalpel in, went missing when I almost stepped on the blade lying on the floor. Couldn't find the sleeve that held it on, so designed a replacement.
It's in two parts. The flat piece fits into the cut-out of the blade holder and stops the blade from leaving, or indeed moving too much. The surround holds these together.
Takes a minute to print and minimal filament. PLA should be tough enough; the only stress is on the surround's tight fit, and it's a static load.