Ender 3 V2 Raspberry Pi Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Printed with White PETG because this is the only white filament I have. It will look better if printed with PLA. I…
- Rating
- 5 / 5
- Likes
- 50
- Downloads
- 224
- Makes
- 1
- Views
- 4,959
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Printed with White PETG because this is the only white filament I have.
It will look better if printed with PLA.
I didn't put a fan in the design because I have modded the original 40mm controller fan with a 80mm fan, it pushes a lot of air through the vents, should also be able to cool down the Pi.
Fan Mods I used: https://www.thingiverse.com/thing:4549738 https://www.thingiverse.com/thing:4548187
Camera Case I used: https://www.thingiverse.com/thing:2987719
I soldered the USB2.0 D+ and D- directly on the controller board, as well as on my RaspberryPi 4. And connected a power wire from the PSU to a LM2596 to get 5V to power the Pi directly from its GPIO pins.
So I don't need to run any cable (except for the camera) outside the case.
The top cover is separated, so future mods can be done easily. I am planning to make another LCD screen into the top cover, for OctoPrint.
I have included the f3d design files so you can make changes and tweaks.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
35%
Filament: Duramic3D PETG White
Notes:
Any material should work.
Controller board
Solder USB D+ D- to a ribbon connector directly on CH340 chip
Category: 3D Printer Accessories