Fan Shroud PCI Slot Cover for 80 mm Fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple model to mount an 80 mm fan for additional cooling of your graphics card.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 44
- Makes
- 0
- Views
- 279
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
Created a simple PCI slot cover shroud to mount an 80 mm fan for additional cooling of my GPU. Can be used with a 2-slot GPU (I've got a Inno3D 4070 Ti Super) and ATX sized MB only!
Fan: Arctic P8 Slim PWM (80x80x15 mm)
A 25 mm fan could be also used but you need to check if it fits with the HD Audio connector which is located in that spot on most boards. I've tested it in my case with the Arctic P8 Max, but I didn't need that extra amount of static pressure.
The fan is currently used as intake to get some cooler air just under the first fan of the GPU. It runs 3-5°C cooler on full load this way. I set fixed RPM in my Bios (40% > 1200 RPM), so no extra noise.
Print the model as provided with a layer height of 0.2 and a line width of 0.38. I set top and bottom layers to 0 and used honeycomb infill with 30%. Set the angle to 30°. Wall lines is up to you - I used 7 just to beef up the mounting holes for the fan. Don't overtighten!
Use some manual support for the mounting hole and take care when removing. Overall thickness is only 1 mm!
PS: If your MB got an extra T-SENSOR connector, you could get a small temperature sensor and mount it on your GPU backplate. This way you can set a more dedicated curve based on the GPU temp. I'm getting one soon and try it out. 🙂