1 / 4
Stand alone Spoolholder for Ender 3 S1 family — image 1
1 / 4

Stand alone Spoolholder for Ender 3 S1 family

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Around 100g to make your S1 spool holder into a stand alone holder.

Rating
0 / 5
Likes
3
Downloads
9
Makes
0
Views
127
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Use your Ender S1 (regular, Pro, Plus) Spoolholder to make a stand alone spool holder.

Using a 20cm roll, the overall height is 27cm.

>> NO SUPPORTS! Print like in the 3rd picture. <<
I used 3 walls and 25% infill, but probably could use less.

I have a shelf above the place I wanted to place the printer, so I wanted something that uses the original spool holder, and since I personally don't like spool holders without a tube in the center, because when the spool is light it sometimes falls rather than rolling.

Luckly I found the aluminum profile model by 3D-science, and just needed to adapt it for a stand alone

The end result is a sturdy spool holder.

Nicely snap in place.

Tip: add some non-slip rubber below!


Note:
If you want to make it shorter in height, you can remix it to make the holder in diagonal and not (almost) in vertical like I did. 

Tags