IKEA Markus armrest handles
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.68 – €4.50 net (excluding VAT)
For file: Markus_armrest_handle_0.4n_0.2mm_PLA_COREONE_2h51m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.09 excluding VAT (range midpoint).
- Weight reported by the author
- 77 g
- Print time reported by the author
- 2.85 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Sturdy and comfortable handle replacements for the IKEA Markus armrests.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 25
- Makes
- 0
- Views
- 146
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Like seemingly everyone else who ever bought an IKEA Markus chair, I found the armrests too tall to fit under my desk.
Since I felt like I also didn't need armrests(corner desk), I decided to go with simple handles instead. And since I am a big dude and I like putting my weight on my hands while I change seating posture, I wanted handles sturdy and comfortable enough to accomplish that.
Print settings:
Layer height: ~0.2
Infill: ~25%
Perimeters: ~3-4 (@0.4mm nozzle)
Top and bottom layers: ~7
Support: Only needed for the bolt holes, suppress it everywhere else.
Brim: Can probably print them without, but probably a good idea to use them since bed adhesion surface is not very large.
Installation:
Use the included bolts for the original armrests. If using brims, put the printbed side inwards to hide any slight defects from cutting/sanding. Make sure the holes in the cloth lines up with the threaded tabs before mounting the handles.