B2-EMO V2 Eye Buck for Vacuforming
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Eye Buck for Vacuum forming his main Eye. I used .5mm clear PETG in a two stage vacuum-former at 150degrees C.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 14
- Makes
- 0
- Views
- 111
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Eye Buck for Vacuum forming his main Eye. NOTE: This model is for his eye lens. It is NOT the eye (shown in green in the photo.). I used .5mm clear PETG in a two stage vacuum-former at 150degrees C.
I used a good pair of scissors to cut out the part. Remove the part by cutting the "flat part of the plastic then carefully make a few thin circumference cuts. The Final Cut should be at the bottom of the small dots. I did two of the eyes at the same time and put a small item on the bed to prevent wrinkles. Plus, you will have a spare eye.
Spend plenty of time sanding it “glass” smooth. excessive layer lines will be reproduced in the eye if they are present.. Also, print in a low layer height. I used .1mm. I used 4 perimeters and 9 top layers with a 25% gyroid infill. I printed the bucks in PETG. I got dimpling on my PLA+ test piece because vacuum sucked so hard and the PLA got just malleable enough it actually created dimples where the infill had gaps underneath.