1 / 2
3D printer two-part noise isolation feet — image 1
1 / 2

3D printer two-part noise isolation feet

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two-part noise isolation feet to reduce the thumping heard through the floor below. Cut about half of the noise.

Rating
0 / 5
Likes
0
Downloads
6
Makes
0
Views
61
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

This is a two-part model using rubber non-slip shelf liner (checkerboard, not solid) between each layer cut allow a folded over once section to fill the entire cup on the main printer foot component. My 3D printer would send loud rapid thumps through the floor during prints.  The results from installation of these feet was a reduction in a little over half the noise being transferred through the hardwood floor to the room below. The folded over rubber section is key to performance; if cut to the full size of the cup, this allows noise transference reduction both vertically and horizontally as it squishes around the printer's standard rectangular feet.  These same feet have worked on both my old printer (Crealty Ender 3 pro) and new printer (Elegoo Neptune 4 plus) and are likely universal.

The correct order of installation top to bottom is:

  1.  3D printer's standard rubber feet

  2.  A folded over rubber shelf liner

  3.  Printer foot

  4.  A folded over rubber shelf liner

  5.  Printer foot bottom

  6.  A folded over rubber shelf liner

  7.  Table or other surface that you set your printer on. 

Tags