1 / 3
Compact Analog FPV Pan and Tilt with Runcam Thumb Mount — image 1
1 / 3

Compact Analog FPV Pan and Tilt with Runcam Thumb Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple pan and tilt module with integrated tangs to allow easy mounting of a Runcam Thumb.

Rating
0 / 5
Likes
1
Downloads
9
Makes
0
Views
123
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

After being unable to find a simple yet robust pan and tilt module that could also house a Runcam Thumb Pro, I made this to suit my fixed wing FPV needs. The part is similar in design to the pan an tilt by Painless360, but this uses a M2 bolt to secure the tilt part to the pan base instead of relying on a 3D printed cylinder coming out of the body. 

You will need a few additional a supplies to assemble the unit:

  1. 2x M2 bolt and lock nut or nut with thread lock 
  2. 4x M1.4 tapping screw or glue
  3. 2x plastic gear 9g servos

Assembly is simple, but requires some finesse. The tilt base was only tested with plastic gear 9g servo, specifically the HXT900 from Hobbyking. Any similar type plastic gear servos should fit without issue. There is not enough space for metal gear servos however. The pan servo should be able to accept any one, as long as the arm can fit in the receptacle. The arm can be glued or screwed in with M1.4 tapping screws.

The analog FPV camera accepts 19mm width cameras and has space for the wire to pass through. The Runcam Thumb mount was designed around the stock mount that ships with the camera so a M2 bolt will be needed to secure it. 

I printed this using PETG because it will be exposed to sunlight and is more bendy than PLA. I found PETG offers better dimensional accuracy, which is important with small bolt hole and servo arm clearances. 

Attached is the FreeCAD source file to modify if it does not meet your needs.

Tags