Nano Pod for iFlight SucceX Whoop
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed the Nano Pod to accommodate the iFlight SucceX Whoop FC + vTx combo. There are cutouts along the bottom edges…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 0
- Views
- 176
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Remixed the Nano Pod to accommodate the iFlight SucceX Whoop FC + vTx combo. There are cutouts along the bottom edges now to not interfere with the stack mounted vTx. There is enough room to fit a XM+ and a Runcam Nano 2.
I also added 2 2.4GHz Antenna holes and a zip tie to the fin to make mounting of all the antennas a lot cleaner.
Rigidity is the same as the original on, at least I couldn't notice a difference. Should be a little bit lighter due to the cutouts though (only .2 grams for my print).
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
1.6
Filament:
sainsmart TPU
white
Notes:
Supports are only needed for the cutouts (lower 3mm of the model). I printed the model at 45mm/s on my direct drive Ender-3 Pro. Not the cleanest but took less than an hour.
Category: R/C Vehicles